Organ needles While the needle is the least
expensive component in any embroidery or
sewing machine
While the needle is the least expensive component
in any embroidery or sewing
machine, it is the most important. High quality, ORGAN
needles designed in cooperation with the
machine builders assure maximum
performance, quality, and economy.
ORGAN needles are
manufactured from special
high carbon, silicon rich steel. We use the latest
state-of-the-art production
techniques to insure high polished eyes for
dependable, smoother stitches,
consistent quality, and fewer thread breaks.
The Organ Needle Company works closely with all of
Japan's sewing machine
builders to design and manufacturer needles for
optimal performance. A machine
builder cannot afford to buy an inferior needle at any
price!
The price quoted is for a pack of 100 needles.

Optional features:
COOL-SEW® NEEDLES
The COOL-SEW (CS) finish was developed to alleviate
needle problems resulting
from the following situations:
(1) Heat Buildup in penetration of synthetic,
chemically treated, or very dense
materials
(2) Materials or residue sticking to the needle
surface or in eye
(3) Excessive sewing thread breakage due to friction
in the eye
As a needle penetrates synthetic, chemically treated
or very dense materials a
great deal of friction may develop. The needle may get
so hot as to actually
melt or fuse the sewn material along the seam. The
needle's heat may melt the
synthetic sewing thread. When the machine stops, the
melted residue may stick to
the needle surfaces as it cools.
The nature of some materials makes them rather
"sticky." Materials such as
rubber, foam, and synthetic fillers stick to surfaces
with which they make
contact. They may stick to needles which penetrate
through them, even at
relative slow sewing speeds. The result may cause
undesirable stitch appearances
as these materials push through or pull up trough
needle holes.
Synthetic threads often have a higher friction
coefficient than natural fiber
threads such as cotton. Passing through the eye of the
needle increases, the
heat of the needles rises, often to temperatures which
will melt the synthetic
sewing thread causing it to break.
Chemical coatings or treatments of threads and
materials may cause troublesome
sewing problems. Bonded layers, waterproofing, dyes,
starches, adhesive, sizing,
or other alterations to any fibers may result in
needle heat-buildup, sticking
problems, excessive thread breakage, and clogged
needle eyes.
The COOL-SEW finish needle's surfaces, even in
the eye, are resistant to
sticking. Its non-sticking finish has a very low
friction coefficient which
prevents excessive buildup and its resulting problems.
Few, if any, material
stick to the surfaces of COOL-SEW needles.
When COOL-SEW needles are used under conditions
described above you can
expect neater stitches, less sewing thread breakage,
less puckered stitches, low
downtime, less defects, and increased
productivity.
COOL-SEW needles are ideal for sewing through
vinyl, synthetics,
chemically treated materials, glued materials,
rubberized goods, nylon, foam,
dense material, and with synthetic threads.


*Number in ( ) are the sizes available for this option.
All sizes are in Nm/Singer sizes. If you need a size conversion, visit our
needle size guide.